Power and Electrical | PF | Power Failure | Check voltage, reset by turning off power for 5 mins or pressing cancel. |
Power and Electrical | CE | Configuration/Wiring Issue | Inspect wiring, verify correct parts are installed. |
Power and Electrical | iC0 | Control System Failure | Press cancel or reset power, consult a professional if needed. |
Water Supply | i10 | Low Water Level | Ensure valve is open, check hose for kinks, inspect inlet valve. |
Water Supply | i20/i40/iF0 | Drainage Problem | Clear hose kinks, clean filters and sump, check disposal knockout plug. |
Water Supply | i30 | Leak Detected | Clean pressure sensor, inspect inlet valve and pump, level dishwasher. |
Water Supply | i60 | Heating Issue | Reset dishwasher, inspect heating element and thermostat. |
Water Supply | HO | Heating Delay | Run hot water before starting, check heating system. |
Rinse Aid | LO | Low Rinse Aid | Refill rinse aid dispenser. |
Rinse Aid | rA | Rinse Aid Switch Issue | Refill rinse aid, check wiring, replace control board if needed. |
Rinse Aid | RE/RF | Rinse Aid Reed Switch Fault | Refill dispenser, replace if error persists. |
Door | CL | Door Not Closed Properly | Ensure door is closed, check switches and wiring. |
Vent | UO | Vent Open Error | Inspect vent wiring, replace vent assembly if necessary. |
Vent | UF | Vent Fan Error | Check fan wiring, replace vent fan if needed. |
Motor and Sensor | i50 | Motor Fault | Reset dishwasher, troubleshoot motor system. |
Motor and Sensor | hs | Hall Sensor Error | Inspect motor and control wiring, replace if faulty. |
Motor and Sensor | tu | Turbidity Sensor Fault | Check sensor wiring, replace sensor if necessary. |
Control Panel | ER | Stuck Button | Press all buttons, inspect panel wiring, replace if needed. |
Relay Test | dP | Drain Pump Test | No action unless error persists. |
Relay Test | FL | Water Valve Test | No action unless error persists. |
Relay Test | rt | Relay Test Active | No action unless test fails. |
Relay Test | Sd | Detergent Dispenser Test | No action unless error persists. |
Relay Test | UL | UL Test Active | No action unless error persists. |