Amika Dishwasher Fault Codes

Amika Dishwasher Fault Codes

Amika Dishwasher Fault Codes (Partial List)

Fault Code Description Possible Solutions
F01 Water Inlet Error Verify water supply functionality, examine inlet hose for potential restrictions, and meticulously clean the inlet valve filter.
F02 Heating Element Error Evaluate heating element integrity, trace electrical connections for potential disruptions, and confirm proper voltage transmission.
F03 Drain Error Thoroughly purge drain filter, investigate potential drainage pathway obstructions, and assess pump operational efficiency.
F04 Water Leak Detected Systematically trace potential moisture sources, scrutinize door seal integrity, and validate all hydraulic connection points.
F05 Overfill Error Examine float mechanism for potential impediments, diagnose water inlet valve performance, and initiate system reset protocols.
F06 Water Temperature Error Assess hot water supply capacity, evaluate thermostat calibration, and diagnose heating element operational parameters.
F07 Detergent Dispenser Error Investigate dispenser mechanism for potential blockages, validate mechanical movement, and verify electronic signaling integrity.
F08 Spray Arm Blockage Comprehensively disassemble and cleanse spray mechanisms, validate rotational freedom, and inspect water jet precision.
F09 Filtration System Fault Execute comprehensive filter sanitization, eliminate potential debris accumulation, and confirm precise filter positioning.
F10 Pump Motor Error Conduct comprehensive motor diagnostic evaluation, verify electrical interconnection stability, and assess impeller mechanical dynamics.
F11 Door Lock Mechanism Error Meticulously inspect latch engagement mechanisms, evaluate switch functionality, and trace electrical continuity pathways.
F12 Water Pressure Sensor Error Systematically cleanse pressure detection components, eliminate potential hydraulic pathway restrictions, and validate sensor connection integrity.
F13 Control Panel Communication Error Execute comprehensive system reinitiation, trace control board wiring complexity, and inspect potential circuit degradation.
F14 Inlet Hose Connection Error Rigorously validate inlet hose attachment precision, conduct comprehensive leak detection, and eliminate potential flow impediments.
F15 Rinse Aid Dispenser Error Perform thorough dispenser mechanism assessment, eliminate potential distribution pathway obstructions, and validate operational parameters.
F16 Drying System Fault Comprehensively evaluate drying fan performance, validate heating element operational characteristics, and inspect ventilation pathway integrity.
F17 Timer Control Error Initiate system reset procedures, analyze timer mechanism precision, and trace control board interconnection stability.
F18 Water Filtration Error Execute comprehensive water filtration component evaluation, eliminate potential blockage scenarios, and confirm precise filter installation.
F19 Spray Arm Calibration Error Meticulously realign and recalibrate spray arm mechanisms, validate water distribution dynamics, and assess potential mechanical inconsistencies.
F20 Detergent Dispenser Calibration Error Execute precise dispenser recalibration protocols, eliminate potential mechanical obstructions, and validate electronic control system functionality.

Important Notes:

  • This is NOT an exhaustive list. Other fault codes may be specific to your Amika dishwasher model.
  • Fault code meanings can vary slightly between models. Always refer to your user manual for accurate information.

What You Should Do:

  • Find Your User Manual: Use your model number, visit the Amika website, or contact Amika support to locate your manual.
  • Check for a Tech Sheet: A detailed “tech sheet” with fault codes may be inside the dishwasher, often behind a panel. Access may require disassembly.
  • Contact Amika or a Certified Technician: If unsure, reach out to Amika support or a qualified technician for assistance.

Leave a Comment

Your email address will not be published. Required fields are marked *