| i10 |
Water inlet problem – Dishwasher cannot fill with water |
- Ensure water supply valve is open
- Check inlet hose for kinks or blockages
- Clean inlet valve filter
- Verify water pressure levels
|
| i20 |
Drainage problem – Dishwasher can’t drain properly |
- Clear drain hose blockages
- Clean dishwasher filters
- Check drain pump for clogs
- Ensure drain hose is not kinked
|
| i30 |
Anti-flood system triggered – Leak detected |
- Inspect for visible water leaks
- Check door seals for damage
- Verify hose connections
- Test float switch
|
| i40 |
Pressure switch issue – Problem with water level detection |
- Inspect pressure switch connections
- Check for blockages in pressure sensor tube
- Test pressure switch operation
|
| i50 |
Motor problem – Issue with main wash motor |
- Check motor wiring connections
- Listen for unusual noises
- Inspect motor bearings
- Test motor windings
|
| i60 |
Heating problem – Water temperature issues |
- Test heating element
- Verify thermostat function
- Check temperature sensor
- Inspect wiring connections
|
| i70 |
Turbidity sensor issue – Water clarity detection problem |
- Clean turbidity sensor
- Check sensor wiring
- Test sensor functionality
|
| i80 |
Circulation pump issue – Water flow problems |
- Check pump for obstructions
- Inspect impeller condition
- Test pump motor
- Verify electrical connections
|
| i90 |
Diverter valve problem – Issue with spray arm water distribution |
- Verify valve movement
- Clean diverter mechanism
- Test valve motor
- Inspect for debris buildup
|
| iA0 |
Water softener problem – Water treatment system issues |
- Verify salt levels
- Inspect resin tank
- Check regeneration cycle
- Test brine valve
|
| iB0 |
Drying system problem – Drying functionality issues |
- Examine ventilation system
- Test drying fan
- Inspect heating element
- Check vapor barrier
|
| iC0 |
Control board communication fault – Electronic control issues |
- Check control board connections
- Test board functionality
- Verify power supply
- Inspect for moisture damage
|
| iE0 |
Water temperature sensor fault – Monitoring issues |
- Test sensor resistance
- Verify sensor wiring
- Inspect for damaged wiring
- Replace faulty sensor
|
| iF0 |
General fault – Multiple potential issues |
- Run diagnostic program
- Inspect all connections
- Reset control board
- Test key components
|
