F&P Dishwasher Fault Codes
| Fault Code | Issue | Solution |
|---|---|---|
| A-Series Fault Codes | ||
| A1 | No Water Supply |
• Verify the water valve is open • Check for proper water pressure • Examine the inlet hose for kinks or clogs |
| A3 | Drainage Issue |
• Inspect the drainage hose for blockages • Check the connection to the drainage system |
| A6 | Loose Spray Arm or Foaming Issue |
• Confirm the spray arm is securely attached • Use dishwasher-specific detergent tablets |
| A7 | Excess Foam Detected |
• Apply only detergent designed for dishwashers • Run an empty cycle to eliminate foam buildup |
| A09 | Sanitize Cycle Failure (DD*C Models) |
• Set hot water supply to at least 65°C (149°F) • Avoid overloading the dishwasher |
| A10 | Water Supply Issue |
• Ensure the water tap is turned on • Check for reduced water pressure or bent inlet hose |
| A20 | Drainage Fault |
• Remove any obstructions from the drain hose • Inspect the outlet connection for clogs |
| A60 | Water Temperature Fault |
• Power the dishwasher off and back on • Contact customer support if the fault continues |
| AD0 | Door Lock Signal Fault |
• Reboot the dishwasher • Seek professional assistance if the problem persists |
| F-Series Fault Codes | ||
| F1 | Flood Detected |
• Shut off the water and power supply • Contact service if the problem remains |
| F2 | Motor Rotor Fault | Clear any obstructions and restart the appliance |
| F3 | Temperature Sensor Fault |
• Confirm the water temperature is under 65°C (149°F) • Install a tempering valve if required |
| F4 | Heating Element Fault | Test the heating element and replace if defective |
| F5, F6, F7 | Lid Faults |
• Cycle the power off and on • Verify the lid closes securely |
| F8 | Electrical Problem |
• Restart the dishwasher • Contact service support if unresolved |
| F9 | Electronics Malfunction | Reboot the dishwasher |
| F30 | Flood Switch Activated | Turn off power and water, then contact service |
| F40, F50, F90 | Electronics Faults |
• Power cycle the dishwasher • Reach out to customer care if the fault persists |
| FA0 | Power Supply Fault | Switch the dishwasher off and on again |
| FC0 | Motor Fault |
• Reboot the dishwasher • Contact customer care if needed |
How to Reset Your Fisher Paykel Dishwasher Fault Codes
- Turn off the dishwasher for at least 30 seconds
- Ensure water supply and drainage are clear and valves are open
- Inspect spray arms and filters for any obstructions
- Power the unit back on to see if the fault persists