| E01 |
Water Inlet Fault |
Dishwasher isn’t filling |
Ensure the water supply is active, and inspect the inlet valve and hose for issues. |
| E02 |
Drainage Fault |
Water isn’t draining |
Examine the filter, drain hose, and pump to clear any blockages. |
| E03 |
Heating Fault |
Water isn’t heating |
Inspect the heating element and thermostat to confirm proper operation. |
| E04 |
Overflow/Leakage |
Too much water or a leak detected |
Review the water level sensor, inlet valve, and hose connections for leaks. |
| E05 |
Motor Fault |
Issue with wash motor |
Assess the motor’s condition and replace if it shows signs of failure. |
| E06 |
Pressure Switch Fault |
Water level detection issue |
Check the pressure switch for proper functionality and replace if needed. |
| E07 |
Turbidity Sensor Fault |
Water clarity sensor issue |
Clean the turbidity sensor thoroughly or install a new one if faulty. |
| E08 |
Diverter Valve Fault |
Water not reaching spray arms |
Inspect the diverter valve for blockages and replace if necessary. |
| E09 |
Water Softener Fault |
Water softener not functioning |
Verify salt levels and clean the regeneration valve for optimal performance. |
| E10 |
Circulation Pump Fault |
Pump not operating properly |
Test the circulation pump and remove any debris that may be obstructing it. |
| E11 |
Drying System Fault |
Dishwasher isn’t drying properly |
Examine the drying fan, heating element, and ventilation system for issues. |
| F1 |
Water Inlet Problem |
Dishwasher isn’t filling |
Ensure water supply is active and the inlet valve is clear of debris. |
| F2 |
Drainage Problem |
Dishwasher is not draining |
Inspect and clean the drain hose, pump, and filter to ensure proper flow. |
| F3 |
Heating Problem |
Dishwasher isn’t heating |
Evaluate the heating element and thermostat for faults and replace if defective. |
| F4 |
Overflow or Leak Detection |
Excess water detected |
Inspect the float switch, sensors, and hoses for any signs of leaks or damage. |
| F5 |
Motor Fault |
Wash motor not functioning |
Conduct a thorough check of the motor and replace it if found faulty. |
| F6 |
Pressure Switch Problem |
Water level sensor issue |
Clean the pressure switch thoroughly or replace if malfunctioning. |
| F7 |
Turbidity Sensor Problem |
Water clarity sensor malfunction |
Ensure the turbidity sensor is clean and operational, replacing if needed. |
| F8 |
Diverter Valve Problem |
Water flow not reaching spray arms |
Clear any obstructions and replace the diverter valve if it is defective. |
| F9 |
Water Softener Problem |
Softener system not working |
Confirm adequate salt levels and clean the regeneration valve for efficiency. |
